FULL CAR PACK NOW LIVE! - https://www.cgtrader.com/3d-model-packs/kyosho-lazer-zxr-zxrr-full-car-pack-with-some-mod-parts
Kyosho Lazer ZX/ZXR left and right rear hub carrier. You will have to play around with the positioning and figure out whats best for you, what works for strength and accuracy. You may have to dremel a little to remove supports in bearing seats with some printers. The 6 top mounting holes are set at 2.5mm but are supposed to take an M3 screw. In the original part you would let the screw cut a thread but to save the part from cracking you either want to drill it out to 2.7 or 2.8mm and then tap it with an M3 tap or heat the part and the screw in boiling water and go for it very carefully. You could just drill it out to 3mm and then put a nut on the end of the screw if you arent bothered about it being slightly different to standard. Ive made the bottom mounting holes 3.1mm but you will probably need to run a 3mm drill bit through it anyway depending how accurate your printer is.Please check out my other files for more RC car parts, Lazer ZX and ZXR parts are being uploaded daily at the moment. I have most parts of the whole car, this has taken me almost a year of my spare time to make all of these. I will shortly be uploading a video explaining some of these parts to my YouTube channel which I will eventually link here. - https://youtu.be/A3WvQG3Msh0?si=Ly0Qf-x2fp1rYVGSI - If you are a Lazer fanatic like me you will want to know that Rubrix Racing have started making parts for the Lazers as of April 2026 and theyre fantastic quality so if youre trying to find a specific part you may want to google them and have a look at their website!