FlameTrooper TankPack 3D print model

This is a 3D printable full scale Flametrooper Backpack. It comprises of over 45 pieces and measures around 60cm when fully assembled. It is scaled for a standard 6 foot Flametrooper costume but feel free to increase or decrease the scale. Part 21 is blank for you to add whatever attachment to your Costume Torso Rear section.

Assembly instructions included, not a difficult build just a quite a number of parts and obviously plastic. I would guesstimate about 2 spools of plastic, perhaps 3.

All parts are triple repair checked, placed flat (or as flat ) as can be at the centre of the build plate. You won't need to do anything other than load and press print. The Joining pins are completely up to you, I do recommend them on the rear loop but everything else they are purely for assisting the lining up and assembling process, ie you can pretty much assemble this without glue if your pin fittings are fairly tight.. (but I do recommend glue!)