*** This 3D-set requires a minimum print surface length of 150mm of your resin 3D-printer***Full set of STL-files to build a Swedish state railroad stake car Litt O in H0-scale. Runs well on both 2- and 3-rail systems.The car is equipped with standard sized NEM-pockets, which allows for any NEM-couplings of your choise.In addition you need: 2x wheel pairs (WHEEL DIAM: 10.3mm SHAFT LENGTH: 24.6mm)2x NEM springs (size 2.0mm diam, 4.0mm length, 0.1 - 0.2mm wire diameter)10-15 gram metal plate to be glued under flatbed floor as ballast (max 50 x 15 x 0.8mm).

Ready-to-print super detailed items set for H0-scale Model Railroad. The Print files (STL-format) with correct supports are included and all neccesary preparations are made to simplify print. Simply download, un-zip, slice and print. Enjoy!

The models are developed and test printed to verify function, detail and printability. Testing has been performed on a range of consumer grade 4k, 6k and 8k resin 3D-printers.

We recommend using 0.3mm layer thickness and one of the following resins for low warp, high strength and super detail:

• Mix of 70% Anycubic ABS-like / 30% Anycubic Tough resin.

IMPORTANT GENERAL NOTE TO AVIOD WARPING / SCEWING:

• WASHING: Wash all items clean from resin preferrably in a washing mashine 6-8 minutes (Anycubic Wash & Cure 2.0)
• POST CURING: Leave all items to dry after wash properly. Preferrably over-night / 24h. All sides, including inside surfaces, MUST be exposed to the UV-light. Recommended time: 4 minutes.
• Paint ALL the details immidiatly after post-curing using a primer. We recommend TAMAIYA Surface Primer Fine Gray. Do not use water based primers.

*The Editorial licence of course includes unlimited printing for your own Model Railroad. However, the 3D models provided in this set must NOT be used for commersial production or re-sale of the 3D-models.