Tom Dixon - Beat Pendant Lights 3D print model
These pendant lamps was modelled (by me) with inspiration from Tom Dixon's Beat Lights 3 Pendant lights are included: Wide, Fat & Tall.
These are fully functional lamps that requires you to print the lamp, install cord, bulb holder and bulb. Sizes: Beat Wide: 112mm tall x 216mm Ø Beat Fat: 183mm tall x 146mm Ø Beat Tall: 261mm tall x 116mm Ø Note: The Beat Tall can be printed in two parts (top & bottom) and afterwards glued together if your printer cannot print the full tall version. Each lamp has a 28mm ring inside that the lamp holder sits within.
Depending on printing material used I suggest using a light bulb with low heat emission such as an energy saver bulb or LED.
Suggestions for bulb & bulb holders:
Bulb Holder: (For E14 Bulb with 28mm thread and clamp ring)
Bulb: (10W E14 bulb in desired colour) Note: bulb should be fairly small to fit inside shade
Disclaimer: Please make your own judgement when building and using this lamp. I will not be responsible for any damage caused by using this model or suggestions given.