Please ensure your printer is able to print larger than 248x200x70mm.

The purpose built offroad recovery rig is now available! *Cat 1 Mammoth front cab is sold separately.*

Aftermarket front shock towers and panhard mount are required. Front and rear inner fenders need to be removed before installing.

Designed for TRX6 (G63 version) wheelbase using 324mm from front to middle axle, 454mm from middle to rear axle.

The TRX6 Cat 1 6x6 Tow Bed enables you to haul a 1/10 scale RC Crawler, so you can carry 2 crawlers out on the trail with ease or stage a recovery scene. The bed comes in at a whopping length of 530mm with 2 different widths that can be further configured if an extra heavy duty job is called for.

To put the bed length in perspective, an Axial SCX10 iii Jeep Gladiator was test fitted which resulted in all 4 tyres on the bed and the rear bumper overhanging off the bed.

With railings attached on the standard width bed flares, the width comes up to 263mm, which is wide enough for most straight axle and portal axle 1.9 RC crawlers. With the railings off however the bed width is 282mm.

If you need more space or the rig you are planning to haul is even wider, using the included wider bed flares and railings will achieve 279mm in width, and with the railings off it gives an even wider 298mm. This should allow most 2.2 rigs to fit on snugly.

To tie down your RC vehicles onto the bed, shackle mounting points and hooks are included. Simple hook on bungee straps or jewelry chains to secure the axle and bumper.

To help access the battery, a battery access hatch is integrated into the bed which is secured using magnets. This means very efficient and hassle free battery changing on the trail.

Some more of the features included in the design:

Wide, standard, narrow style fenders to match the Cat 1 Mammoth’s widthScale realistic rear bumper with towing eyes, tow hook, mudflaps, functional light bucketsFully functional light bucketsHeadache rack with meshAnd more

TRX6 body mounts for the flatbed are included.

Please download and use the newly updated TRX4 Cat1 front cab and mounts from the Cat 1 Mammoth, this will provide an optimal fit for TRX4 and TRX6 chassis.

Also note rear fenders/shock towers will need to be removed as the shock towers provided are more optimized for the bed.

Please be sure to check out the instruction manual and gather all required hardware for assembly.

It is highly recommended to read the instruction manual before purchasing, to ensure you have all the required tools and hardware to assemble this body.

Assembly instructions:

View the link below to download the assembly instructions

aheadrc.com/manual

Should you need any help, please do not hesitate to contact us!

FDM printing:

PLA+ filament

0.2mm-0.4mm layer heights

15-30% infill density

Supports are necessary