HERMIONE GRANGER WAND - HARRY POTTER 3D print model
“That foul, lying, twisting old gargoyle! You see what she’s up to? It’s her thing about half-breeds all over again — she’s trying to make out Hagrid’s some kind of dim-witted troll, just because he had a giantess for a mother — and oh, it’s not fair, that really wasn’t a bad lesson at all — I mean, all right, if it had been Blast-Ended Skrewts again, but thestrals are fine — in fact, for Hagrid, they’re really good!”
This is my Hermione Granger Wand design. Inspired from Harry Potter!
This model made by me! Modelling time 2 hours! It is high-resolution model. About 170.000 polygons. Two part. But full wand (without split) is included. Made in cinema 4D. NO SUPPORT! JUST PRINT! This wand is two part. You need to glue them after print. If you print 100 micron (0.1mm), you won't need sandpaper! :)
CREALITY CR-10 PRINT SETTINGS
100micron (0.1mm) Layer height %70 infill NO SUPPORT 60 degrees Bed heat 200 degrees Nozzle heat
5 hours print time!
I hope you like guys!
You can follow my Instagram pages! @tolgaaxu @buyucusokagi
If you have any question about my designs or anything, please do not hesitate to write me a message! See you on next projects!