You dare use my own spells against me, Potter? It was I who invented them - I, the Half-Blood Prince! And you'd turn my inventions on me, like your filthy father, would you? I don't think so . . . no.This is my Severus Snape Wand design.Inspired from Harry Potter!

This model made by me!Modelling time 2 hours!It is high-resolution model. About 140.000 polygons. Two part. But full wand (without split) is included.Made in cinema 4D.NO SUPPORT! JUST PRINT!This wand is two part. You need to glue them after print.If you print 100 micron (0.1mm), you won't need sandpaper! :)

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height%70 infillNO SUPPORT60 degrees Bed heat200 degrees Nozzle heat

6 hours print time!

I hope you like guys!

If you have any question about my designs or anything, please do not hesitate to write me a message!See you on next projects!