“Can you believe our luck?” said Ron miserably, bending down to pick up Scabbers. “Of all the trees we could’ve hit, we had to get one that hits back.”

This is my Ron Weasley Wand design. Inspired from Harry Potter!

This model made by me! Modelling time 2 hours! It is high-resolution model. Two part. But full wand (without split) is included. Made in cinema 4D. NO SUPPORT! JUST PRINT! This wand is two part. You need to glue them after print. If you print 100 micron (0.1mm), you won't need sandpaper! :)

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height %70 infill NO SUPPORT 60 degrees Bed heat 200 degrees Nozzle heat

5 hours print time!

I hope you like guys!

If you have any question about my designs or anything, please do not hesitate to write me a message! See you on next projects!

QuotedWho is Ron Weasley?Ronald Bilius "Ron" Weasley is a fictional character in J. K. Rowling's Harry Potter series. His first appearance was in the first book of the series, Harry Potter and the Philosopher's Stone as the best friend of Harry Potter and Hermione Granger.Quoted