This is my Narcissa Malfoy Wand design. Inspired from Harry Potter!

This model is made by me! Modelling time 4 hours! It is a high-resolution model. About 120.000 polygons. Two part. But full wand (without split) is included. Made in cinema 4D. NO SUPPORT! JUST PRINT! This wand is two part. You need to glue them after print. If you print 100 micron (0.1mm), you won't need sandpaper or any finishing technique! :)

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height %40 infill NO SUPPORT 60 degrees Bed heat 200 degrees Nozzle heat6 Hours Printing Time ( Depending on the size of your wand and model of your printer! )

I hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message! You can also send me a message for your bulk purchase to. See you on next projects!

QuotedIn 1998, Narcissa gave her wand to her son Draco after his own was taken by Harry Potter during a skirmish in Malfoy Manor. It is unknown if Narcissa used another wand during this time.[1] Draco lost it in the Room of Requirement while fighting Harry for Rowena Ravenclaw's Diadem, and it was subsequently destroyed when Vincent Crabbe unleashed Fiendfyre in the room.Quoted