Three wide drawers in the large footprint — 50 mm more bench per drawer than a medium block.

WHAT IT ISThe large units run 200 mm across rather than 150, which takes each drawer to 186 mm of front width: a full row of tools, a whole category of parts, or a set of bases laid out flat. Three shallow drawers, so the extra width goes into separating things rather than piling them.

AT A GLANCEEnclosure: 200 × 150 × 150 mm (W × D × H)Drawers: 3x — 186 × 145 × 42 mm (W × D × H)Module: Large, 200 mm footprintMagnets: 6 mm disc magnets in the side pockets (optional)Printing: no supports required

INCLUDED• Enclosure, printed in one piece• 3 × drawers, 186 × 145 × 42 mm

BUILT TO COMBINE

Every unit in this range is built on the same two rules: a shared footprint grid, and a shared magnet pattern. Units sit flush with their neighbours and lock there with 6 mm disc magnets seated in the side pockets, so a row stays a row while you pull drawers in and out of it. Drawer blocks, top units, racks and holders all use that same grid, which is what lets a bench grow a unit at a time and still line up.

PRINT NOTES

Files are modelled full size in millimetres and print without supports on a typical FDM machine. Magnets are optional — the pockets can be left empty, in which case units simply stand beside each other instead of locking. Print at 100%: the magnet pockets and the module depend on it, so scaling is not supported.

LICENCE

The files are for personal use only. You may not resell, share or redistribute the digital files, and you may not sell physical prints made from them. Independent design, no affiliation with any other company.