This is my Minerva Mcgonagall Wand design. Inspired from Harry Potter.
You won't need a support for this wand.
Share your prints with me! :)

This model made by me!
Modelling time 2 hours!

2 and 3 Parts version included.
NO SUPPORT! JUST PRINT!
If you print 100 micron (0.1mm), you won't need sandpaper! :)

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height
%60 infill
NO SUPPORT
60 degrees Bed heat
200 degrees Nozzle heat

4 hours print time!

I hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message!
You can also send me a message for your bulk purchase to.
See you on next projects!

INFO about Minerva McgonagallQuotedProfessor Minerva McGonagall , O.M. (First Class),[11] (b. 4 October,[1] 1935[2]) was a half-blood witch, the only daughter of Muggle Robert McGonagall and witch Isobel Ross. She had two younger brothers, Malcolm and Robert Jr. Minerva was a registered Animagus who attended Hogwarts School of Witchcraft and Wizardryfrom 1947-1954 and was Sorted into Gryffindor House (but it took the sorting hat 5 ½ minutes to decide if she was Gryffindor or Ravenclaw, therefore making her a Hatstall).Quoted