Clamping Christmas Tree Stocking Hanger Free 3D print model

Are you constantly worried that your stocking hanger will fall off the mantle? This clamping stocking hanger is the solution. This is a Christmas Tree Stocking Hanger that clamps onto the mantle, so there is no chance it will fall off.

Print Instructions

• Material: PLA
• Supports: No
• Orientation (print everything in an orientation to maximize strength and minimize supports):
  • Print the Treetop on its bottom
  • Print the Tree Body Halves on their flat sides
  • Print the Nut on its bottom
  • Print the Bass Body on its side
  • Clamping Ring on its bottom

Parts

• Treetop (included)
• Tree Body Half 1 (included)
• Tree Body Half 2 (included)
• Nut (included)
• Base Body (included)
• Clamping Ring (included)
• Stocking (not included)

Colors

It is suggested to print the pieces to the tree in green and the pieces to the base in wight.

Assembly

• Measure the thickness of your mantle and print the corresponding base thickness (there are bases that are compatible with mantles in thicknesses of a few millimeters to 100 mm)
• Print the rest of the pieces
• Put the two tree body halves together
• Screws the nut onto the bottom of two tree body halves
• Screws the treetop onto the top of two tree body halves
• Screw the tree in to the base body
• Screw the clamping ring on to the tree
• Glue the clamping ring on to the tree (optional)
• Clamp the assembly onto the mantle
• Put the stocking on the assembly

If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.

If you want to support creation of more models like this one, you can subscribe to my Printables Club (at https://www.printables.com/@Devise3D#join:451) or you can purchase an individual model on CGtraitor (at https://www.cgtrader.com/devise3d).