I made this model to replace one of my broken zipper pull. I uploaded the Meshmixer file if you want to make changes and also I uploaded my CURA Miniature profile for an easy print.The print takes about 40 minutes with my profile

You have to superglue the clip on the model just to be sure it stays in place even though they are quite a perfect fit (at least on my prints)In case the clip doesn't fit the hole, try to scale it a little bit. (it can happen)

Printing settings:

Infill 20 %

Supports: lines

Brim is needed for a better bed adhesion (I printed it on glass)

Speed:30mm/s

Have fun printing on mini Vaders and thank you for your download. Please don't forget to leave a feedback of the model.