This is a quite simple model of a drawer knob. It can be used for any handle that the whole in the piece of furniture is 4 mm in diameter. You will also need a 4 mm, in diameter, screw that is 10 mm plus the length needed to go through the piece of furniture.

Print Instructions

• Material: This model works perfectly fine when printed with PLA.
• Orientation and supports: The best orientation to print this in is on its side so that the grain of the print goes against how the force from the screw will be applied to it. Lay the print on its side and support it.

Pieces

• Drawer knob (included)
• Screw (4 mm diameter screw with a length of 10 mm plus the thickness of the furniture you are using the handle for) (not included)

Assembly

• Put the screw through the hole in the furniture
• Screw the handle on to the screw

If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.