Wolfbox Camera Mounting Block for Behind License Plate Free 3D print model

Instructions:I printed this small mounting block using ABS @ 100% infill.

I drilled about a 5/8or 3/4 peep hole near the center of our truck's license plate. I attached the Wolfbox camera to this 3D printed block using the common Wolfbox rear camera bracket, using two screws. Then I attaced the the 3D block to the backside of our licence plate using a piece of double stick foam tape. I used a helper to see that the camera lens was centered with the peep hole.

Then I drilled two small holes through the front of the plate and into the mounting block. I used to small screws to fasten the block to the plate because I did not trust the double stick foam tape.

The result is a very clean/flush camera mount that is protected from being bumped. We added another rear camera to our camp trailer (diagram).

Check out my other 3D designs or visit us at TearDropCampNews on YouTube...