This is a tray for small parts etc.

In the case of two or more, you can connect to each other.

It is suitable for storing accessories, parts, screws and so on.

Dimentions(unit:mm): Outside:W83xD83xH25 / Inside: W77xD77xH24

In the case of ABS, there is a possibility of warping. Therefore PLA is recommended.

Depending on the accuracy of the printer, the joint may be tight or loose.

Please do not put it when it is tight. The case may be damaged or injured.

If it is tight, Please polish and spread the gap.

If it is loose, Please paste a tape etc. and narrow the gap.

By the way, the gap of the joint part is designed to 0.2 mm.

3D Printer is FLASHFORGE Adventurer 3.

Thank you for viewing.