Feudal Guard Super Battle Tank Destroyer 3D print model

what are the dimensions of the largest piece? I want to check if it will fit my build area. Thanks

what are the dimensions of the largest piece? I want to check if it will fit my build area. Thanks

This model is absolutely gorgeous and fits right into certain games aesthetics. The pre-supported files for resin were sufficient with only one partial fail on the bottom section of the hull, below the body so it won't be visible and it'll easily be patched with some milliput. one suggestion I could make for supports is to add a some small connecting supports between the track wheels. Due to the method of printing, the wheeIs had a bit of warping on the bottoms of each wheel (The tracks are printed vertical to the bed). I also want to forewarn anyone who is considering purchasing and printing this tank that if you plan on fully magnetizing the weapon options for the turrets, hull and sponsons, which I would recommend unless you really want to print more than one of these, than 100% buy a couple of extra bottles of resin in advance because the full model and all weapon options take well over a liter of resin. The most resin consumed will be on the tracks if you plan on loading the bed with the front, back and top of the sponson in one print run. I printed mine on an anycubic Photon Mono SE and the track prints alone consumed an entire VAT in one run.

просто монстр

amazing