50mm Wrathful Barbarian 3D print model

3D model descriptionWrathful Barbarian model for Necropolis theme, Model size, 50 mm, Base size 40 mm. File comes with four models including pre-supported and non pre-supported models

You may 3D print this for personal use, but commercial sales of physical and digital prints are prohibited

3D printing settingsMachine: Printed on the Elegoo Saturn 3 Ultra with standard photopolymer resin, Resolution - 11520 x 5120 px. Size - 218.880 x 122.880 x 260.000.

Print Settings: Layer height - 0.050 mm, Bottom Lift Distance - 3.000 + 4.000

Bottom Later Count - 2, Lifting Distance - 3.000 + 4.000

Exposure Time - 2.500 s, Bottom Retract Distance - 5.500 + 1.500

Bottom Exposure Time - 35.000 s, Retract Distance - 5.500 + 1.500

Transition Layer Count - 8, Bottom Lift Speed - 320.000

Transition Type - Linear, Lifting Speed - 90.000 + 320.000

Transition Layer Interval Time Difference - 3.61 s, Bottom Retract Speed - 320.000 + 90.000

Waiting Mode During Printing - Resting TimeRest Time Before Lift - 0.000Rest Time After Lift - 0.000Rest Time After Retract - 1.000

Matching Resin Mode - Standard Resin_Normal

Advance

Bottom Light PWM - 255 /Light PWM - 255 /Picture Grayscale - 255

Anti-aliasing - None

Once done printing, use gloves and Remove supports before wash. For complicated issues with supports, use X-Acto knife. Downloads also comes with original model to customize supports for customers. After wash Cure the models in a curing station for approximately one minute and thirty seconds. All models were imported and printed from Chitubox basic.