Elvish Lantern

Elvish Lantern 3D print model

Hi there!

I created a The Lord of the Rings inspired Elvish Lantern. I am happily using it on my bookshelf. I placed a LED candle inside it. There is a hole underneath the lantern for the purpose of putting candle. After putting your LED candle, you can easily close it with the lantern's cover.

You can print it easily and WITHOUT SUPPORT.

Please contact me if you have any questions.

3D PRINTING SETTINGS Printed with Anycubic Mega S 0.15mm Layer height %40-50 infill 60 degrees Bed heat 200 degrees Nozzle heat

tolgaaxu
tolgaaxu
Wow I would love to see this in my wedding :))
tilbe
tilbe
oh thank you so much :)
tilbe
tilbe
thank you :)
M
malcolm75
Hi, I was wondering if this can survive the outside elements or is it more of an inside object? Thank you!
tilbe
tilbe
Hi there, it is more about the kind of filament you use to print the model. I found this information "PLA can easily last several years outside depending on your environment, humidity, heat and levels of sun that affect it. If you happen to have the PLA under some protective shade which prevents rain and the sun from affecting it, then a PLA print should last very long outside."
F
fatihfnd
https://www.etsy.com/ca/listing/856403187/elvish-fairy-lantern?ref=shop_home_active_2&crt=1 Merhabalar. Burada sizin modelinizi basıp satan birisi var. Umarım izin almıştır. haber vermek istedim
tilbe
tilbe
Kaldırması için hemen iletişime geçtim. Çok teşekkür ederim duyarlılığınız için.
tilbe
tilbe
thank you :)
Item rating
3 0
Recommended
Very detailed model, looks very nice when printed. However I did run into problems because the base has some areas that are undercut and therefore the model does not stick well to the build surface, a wide brim is required. Also because of the undercut of the base in some areas some filament can not stick to the layer below. i had to do some Gcode editing to move layers around until I got a good print.
Recommended
I increased the size to 130% to accommodate a larger candle. It's a long print, but it looks great so far.
Elvish Lantern
$32.00
 
Editorial License 
Elvish Lantern
$32.00
 
Editorial License 
Response 83% in 12.7h

3D Model formats

Format limitations
  • 3D Studio (.3ds) (2 files)7.85 MB
  • Autodesk FBX (.fbx) (2 files)10.7 MB
  • Stereolithography (.stl) (2 files)20.8 MB
  • Cinema 4D (.c4d) (2 files)21.7 MB
  • OBJ (.obj, .mtl) (2 files)43.3 MB

3D Model details

  • Publish date2020-08-01
  • Model ID#2540752
Help