A pack of 10 climbing hold files plus 2 bonus files. This pack includes jugs, pinches, crimps, edges, ledges, a pocket, and a foothold.

This is my first large collection of climbing holds that I've designed so enjoy! I've used them quite a bit on my home training wall and they have certainly made climbing at home much more viable, as having more versatile holds makes climbing a lot more fun. And buying climbing holds is extremely expensive so I've opted to design a bunch of my own to use as it's a MUCH cheaper alternative.

1. Blue Rhino Edge
   A big edge to crimp on with two hands
2. Blue Cranial Pinch
   Large slightly positive pinch
3. Red Undulated Pocket
   Pocket hold for two fingers
4. Blue Rock Fungus Edge
   An edge for half crimping with maybe a slight thumb catch, could be used as a mini jug on more vertical walls
5. Yellow Behemoth Ledge
   A large ledge that can be used for reaching far to with a slight pinch or used in compression or even layback boulders, this is a versatile hold with many different capabilities
6. Pink Clam Jug
   A medium sized jug
7. Purple Layered Crimp
   A medium sized crimp with an incut edge that may require a full crimp depending on the wall angle
8. Purple Cobble Ledge
   This incut ledge hold can be used as a small jug or an undercling
9. Small Pink Layered Crimp
   A small crimp but with a nice incut edge that probably doesn't require a full crimp on most wall angles
10. Red Colony Foothold
    A generally larger size foothold that can be used on any wall angle and has a moderately sized edge#### Bonuses:
11. a. Blue Rhino Crimp
    A smaller version of the Blue Rhino Edge that is a small crimp that will probably require full crimping on moderately angled walls
12. b. Small Blue Cranial Pinch
    A smaller version of the Blue Cranial pinch that presents more of a challenge than its larger counterpart

The Yellow Behemoth Ledge and Blue Rhino Ledge were printed diagonally to fit on a standard size 3D printer.

All holds have at least 1 bolt hole and 1 screw hole, or 2 screw holes to prevent spinning of the holds. If there is a hold that you think doesn't need bolts leave a comment and I will upload a version with only screws.

I printed these holds with at least 30% infill and 5 walls, however, I only weigh about 145 pounds so please be responsible and print the holds strong enough so a hold doesn't break. I have never had one break on me in any way even when screwing them to the wall with an impact driver.

My next pack will be a bunch of holds with a similar theme, but for my first pack I wanted a bunch of different types of holds to offer a variety!

Thank you!

Fuzzy Skin Settings:

• Fuzzy skin thickness = 0.3 (mm)
• Fuzzy skin density = 6.0 (1/mm)
• Fuzzy skin Point Distance = 0.1667 (mm)