Great! fast, I have printed in CA for just $46 usd with shipping using PETG material.
Great replacement for Logitech rudder pedals. However, the screw holes were about 1/64 in. too small I needed to be drilled out.
Great model. Perfect size for the Saitek Pro Flight rudder pedals. The only problem I had was the mounting holes were too small and would not accept the screws, so I had to drill out each hole (with the drill on the slow setting) with a drill bit 1/64 larger than the holes, being careful not to bust through the bottom, so I could slide the screws down into them. This took a while to do and it required a lot of clean-up afterwards. If the holes going through the pedal were 1/64 larger, this model would've fit perfectly without any post-processing.
I m happy with the service. I am anxious the see the final result of the printing.
The buyer left positive feedback on this model
