Initially, the plan was to mount the printer to the wall but I noticed I needed to service the printer quite often.It was such a pain but* to keep on moving it since my electronics are behind the printer and lots of people were saying that the printer should have a little bit of movement otherwise there will be artifacts on prints.I was looking for a brace that would hold both outside and inside but couldn't find one so I made this. Just contact me if you also want a brace for 2040 or a logo of your choice in the brace/bracket.

All holes utilize M3x10mm bolts and Tnut. 4 outside (pair M4-Tnut) and 4 inside.If you also want to use M4 bolts, I can modify it just contact me.

Print settings:0.20 or 0.16 Layer Height ASA/ABSI use 60 perimeters/walls. I am not a fan of using 100% infill as the nozzle goes everywhere.

Just for coffee, please. Thank you!