This is a dash that I drew for my 1/8 Scale 3d Model. It is as acurate as I could interpret it. I know the bottom glove compartment lid and the ashtray is not 100 % correct but as close as I could judge. I Have printed it on my Anycubic vyper and it printed fine. However the detail is not as sharp as on a resin printer because they are very fine. Resin printing gives a better finish. My resin printer is to small to print the dash in one complete piece. The steering-wheel is loose and comes with a pin. The Hub is separate too. The indicator levers is separate too. I would suggest to glue the pin to the steeringwheel once it is pushed through the hub and then glue the hub to the dashboard.