This motor is based on the 911 SC with weber carbs. The model I made it for is the 1978 Martini Safari 911.Exhaust setup is for performance without heater boxes.

It is intended for 1/8 Scale. Printing it in a smaller scale might cause issues with too thin walls etc.The file is uploaded all elements in place. They are all seperate and solid.

Each element can be exported seperately for printing.

The colours shown in the images are just the basicc colours I assigned to the objects as I went a long.They are not mapped or UV mapped colours for rendering. I have no I dea how to do that or make a model render ready.The model was purely for 3D printing purposes.

Resin printing gives a much better result as to MDF and the process is a lot faster.The parts will need a bit of sanding and adjustment to fit perfectly, before assembly can begin.A Dremel tool is highly recommended to aid in trimming and sanding in corners and edges.

The spark plug leads I ended up using electrical wire during the production of the actual print. I did not use the 3D part in the build. I was scared that it is to small for printing.