Ford Mustang GT500 Eleanor Slot Car Chassis 3D print model
3D printable chassis 1:32 scale slot car chassis to sit under the Ford Mustang 'Eleanor'; https://www.cgtrader.com/3d-print-models/hobby-diy/automotive/mustang-gt500-eleanor-printable-body-car
This is a sidewinder setup chassis with a brace to hold the motor and rear axle in place. It has been designed to accommodate a Slotting Plus guide.
It is apprximately 47mm wide, the body model is oversized and needs to be scaled down to rough 44% of its original size to be approximately 1:32.
6x M2.6 screws are recommended; two to hold the body on and four for the motor mount.
Chassis is sufficiently wide enough to place for a standard magnet.