Hey everyone! I’m excited to share this fun articulated frog model with you.

The frog features smooth articulated joints that allow the legs to move naturally, making it great as a desk toy, display piece, or something fun to sell as a physical print. The wide feet and expressive eyes give it that classic tree frog look that really pops when printed in bright colors.

Recommended Print Settings:

• Layer Height: 0.15–0.2 mm
• Infill: 10–15%
• Perimeters/Walls: 2–3
• Supports: Not required - model comes with premade supports.
• Material: PLA recommended
• Orientation: Print flat on the build plate

Printing Tip:After the print cools, gently move each leg to loosen the joints. They should articulate smoothly once flexed a few times.Also make sure your print bed is clean and properly leveled to ensure good adhesion, especially since the model has multiple contact points.

Scaling Notice:This model is carefully tuned for smooth articulation at its original size. Scaling the model up or down may affect joint tolerances, causing parts to become too tight or too loose.