Oneplus Nord 4 case with stand or without stand. The case is study and rounded and offers protection of the sidebuttons aswell as slight extrusion on the top and bottom of the front so the phonescreen does not touch the surface if laying face down. Should be printed with hard TPU (72D) on a 0.4mm nozzle or some of the thin walls cannot be printed. Both cases should be printed with supports which are added in the 3mf files, which also contains the other parts for each of the prints along with recommended layerheight (0.12mm), walls and support material. The case with the stand is made to also fit a 6cm magentic ring within the stand. The sidebutton is simply placed into side before the phone is placed in the cover and it is not necessary to glue anything into place.To assemble the stand, you first must remove all supports and push the two pins of the stand into the case, which can be done with a small flathead screwdriver. Next the 4 splits must be pushed in as shown in the split assembly photo, where it is important to place the acute angle bevel downwards as it is used to lock the stand pins into place with the inversed bevel in the case. This can also be done with a small flathead screwdriver.Please feel free to message me with changes of the case, assembly or print settings.

Happy printing! - 3D by JM