35mm Film Hanging Hook and Drying Weight 3D print model

This device is to hang 35mm film as well as to be a weight to attach to the end of a strip 35mm film while it dries after developing and fixing.

Yes, it is a job that can be easily done with a clothespin.

However, if you are washing an already processed and cut negative strip, you can’t attach a clothespin as you normally would because the clothespin will attach on the image area. This hanger/weight attaches to the film strip by the sprocket holes without touching the negative image area.

I also have included a hanger with the hook at 90 degrees and a double hook in opposite directions to prevent the hanger from accidently popping off the clothesline.

Also, it’s easier to print this than a clothespin. And who knows maybe there are people out there that are san clothespins.

I hope you find it useful.

Tom