A paper towel dispenser in two sizes — one that fits the run, one that holds more.

WHAT IT ISA roll dispenser built into the range rather than sitting beside it: the 047M uses a standard 150 mm footprint, and the 048XL doubles it to 300 mm for a longer roll or heavier use. Check your build volume before choosing the 048XL — its 300 mm width is larger than most printers.

AT A GLANCEEnclosure: 047M: 150 × 150 × 150 mm — 048XL: 300 × 150 × 150 mm (W × D × H)048XL largest part: 300 × 150 mm — needs a 300 mm bedModule: Medium, 150 mm footprint — 048XL is 300 mmMagnets: 6 mm disc magnets in the side pockets (optional)Printing: no supports required

INCLUDED• 047M dispenser, 150 mm module• 048XL dispenser, double width

BUILT TO COMBINE

Every unit in this range is built on the same two rules: a shared footprint grid, and a shared magnet pattern. Units sit flush with their neighbours and lock there with 6 mm disc magnets seated in the side pockets, so a row stays a row while you pull drawers in and out of it. Drawer blocks, top units, racks and holders all use that same grid, which is what lets a bench grow a unit at a time and still line up.

PRINT NOTES

Files are modelled full size in millimetres and print without supports on a typical FDM machine. Magnets are optional — the pockets can be left empty, in which case units simply stand beside each other instead of locking. Print at 100%: the magnet pockets and the module depend on it, so scaling is not supported.

LICENCE

The files are for personal use only. You may not resell, share or redistribute the digital files, and you may not sell physical prints made from them. Independent design, no affiliation with any other company.