1/12
Thirty paint pots around a corner, in a modular format whose largest part is 200 × 200 mm.
WHAT IT ISA corner rack: thirty pot slots wrapped around 90°, built as a centre section and a side rack so the largest part is 200 × 200 mm — check your bed is at least that. It closes the end of two runs at once.
AT A GLANCEDimensions: 300 × 300 × 150 mm (W × D × H) assembled — a 200 × 200 × 150 mm centre and a 150 × 100 × 150 mm side rackCapacity: 30 × paint pot slotsLargest single part: 200 × 200 mm (modular format)Module: Corner, 300 mm footprintMagnets: 6 mm disc magnets in the side pockets (optional)Printing: no supports required
INCLUDED• Corner centre rack, 200 × 200 mm• Side rack, 150 × 100 mm• 30 × paint pot slots across the two
BUILT TO COMBINE
Every unit in this range is built on the same two rules: a shared footprint grid, and a shared magnet pattern. Units sit flush with their neighbours and lock there with 6 mm disc magnets seated in the side pockets, so a row stays a row while you pull drawers in and out of it. Drawer blocks, top units, racks and holders all use that same grid, which is what lets a bench grow a unit at a time and still line up.
PRINT NOTES
Files are modelled full size in millimetres and print without supports on a typical FDM machine. Magnets are optional — the pockets can be left empty, in which case units simply stand beside each other instead of locking. Print at 100%: the magnet pockets and the module depend on it, so scaling is not supported.
LICENCE
The files are for personal use only. You may not resell, share or redistribute the digital files, and you may not sell physical prints made from them. Independent design, no affiliation with any other company.
REVIEWS & COMMENTS
accuracy, and usability.

