Here’s what’s new:

• Bigger, stronger rings
• Choose your preferred layer height (no longer locked at 0.3)
• Improved support structure
• More uniform adhesion between ring layers
• Massive polygon reduction for smoother slicing – no more lag or crashes

Recommended print settings:

• Use a layer height of 0.1, 0.15, or 0.3 mm – 0.3 mm is recommended for best results.
• Avoid other values like 0.28 mm, as the design relies on very precise geometry.
• Set both first and other layers to the same height.

Troubleshooting tip:If rings detach mid-print, it could be due to collisions while moving between rings.To prevent this, use a Z lift of 0.5 mm.