Tengen Uzui – Sound Hashira 3D Printable Statue
Bring the Sound Hashira to your collection with this detailed fan-made 3D printable statue of Tengen Uzui from Demon Slayer: Kimetsu no Yaiba.
Tengen is presented in a dynamic combat pose wielding his iconic dual Nichirin cleavers connected by a chain. The statue features his distinctive headband, jeweled accessories, muscular physique, Demon Slayer uniform, and flowing white haori.
The display base incorporates dramatic sound and explosive effects, creating a powerful centerpiece for an anime or 3D-printing collection.
Features
- Tengen Uzui character statue
- Sound Hashira design
- Sound Breathing theme
- Dynamic dual-sword combat pose
- Dual Nichirin cleavers
- Connected weapon chain
- Signature jeweled headband
- Detailed Demon Slayer uniform
- Muscular character sculpt
- Explosive and sound-themed display effects
- Detailed display base
- Designed for resin 3D printing
- Suitable for collectors and anime fans
- Scalable to different display sizes
3D Printing
The model is designed primarily for resin 3D printing to preserve the fine details of the face, hair, accessories, weapons, clothing, chain, and display effects.
It can also be adapted for FDM printing with appropriate scaling, orientation, and support settings.
This is a fan-made 3D model inspired by the Demon Slayer franchise.
Demon Slayer: Kimetsu no Yaiba and Tengen Uzui are the intellectual property of their respective rights holders. This model is not an official or licensed product.
Recommended Printing SettingsResin / MSLA
Recommended for maximum detail.
- Layer Height: 0.03–0.05 mm
- Resin: Standard or high-detail resin
- Supports: Required where necessary
- Orient the model to reduce large flat cross-sections
- Carefully support the dual swords, hands, chain, hair tips, headband accessories, and effect elements
- Pay particular attention to thin chain and weapon sections
- Check for islands and unsupported areas before printing
- Hollow large sections when appropriate
- Add suitable drainage holes when hollowing
- Wash and cure according to your resin manufacturer's instructions
FDM
The model can also be printed using FDM with suitable settings.
Suggested starting settings:
- Layer Height: 0.12–0.20 mm
- Nozzle: 0.4 mm
- Infill: 10–20%
- Supports: As required by the slicer
- Brim: Recommended for tall or narrow sections
- Increase model scale for small details
Post Processing
- Remove supports carefully.
- Wash and cure resin prints according to the resin manufacturer's instructions.
- Sand visible support marks where required.
- Prime the model.
- Paint Tengen and the sound/explosion-themed display base.
- Carefully assemble separate weapons, chain, or effect components if applicable.
- Apply a protective clear coat if desired.
Always inspect the model in your slicer before printing and adjust orientation and supports according to your printer.
