Obanai Iguro – Serpent Hashira 3D Printable Statue
Bring the Serpent Hashira to your collection with this detailed fan-made 3D printable statue of Obanai Iguro from Demon Slayer: Kimetsu no Yaiba.
Obanai is presented in a dynamic combat pose with his distinctive twisted Nichirin katana, striped haori, bandaged lower face, long dark hair, and his white snake companion wrapped around him. The statue features a dramatic serpent-themed display base with sculpted rock, smoke, and atmospheric effects inspired by Serpent Breathing.
Designed as a premium collectible display piece, the model focuses on detailed facial features, hair, clothing folds, sword geometry, snake details, and the surrounding display environment.
Features
- Obanai Iguro character statue
- Serpent Hashira design
- Serpent Breathing theme
- Dynamic katana combat pose
- Distinctive twisted Nichirin katana
- White snake companion
- Signature striped haori
- Detailed Demon Slayer uniform
- Bandaged facial details
- Serpent-themed display base
- Sculpted environmental effects
- Designed for resin 3D printing
- Suitable for collectors and anime fans
- Scalable to different display sizes
3D Printing
The model is designed primarily for resin 3D printing to preserve the fine details of the face, hair, clothing, sword, snake, and display effects.
It can also be adapted for FDM printing with appropriate scaling, orientation, and support settings.
This is a fan-made 3D model inspired by the Demon Slayer franchise.
Demon Slayer: Kimetsu no Yaiba and Obanai Iguro are the intellectual property of their respective rights holders. This model is not an official or licensed product.
Recommended Printing SettingsResin / MSLA
Recommended for maximum detail.
- Layer Height: 0.03–0.05 mm
- Resin: Standard or high-detail resin
- Supports: Required where necessary
- Orient the model to reduce large flat cross-sections
- Carefully support the sword, hands, hair tips, clothing edges and snake
- Pay particular attention to thin sword and snake sections
- Check for islands and unsupported areas before printing
- Hollow large sections when appropriate
- Add suitable drainage holes when hollowing
- Wash and cure according to your resin manufacturer's instructions
FDM
The model can also be printed using FDM with suitable settings.
Suggested starting settings:
- Layer Height: 0.12–0.20 mm
- Nozzle: 0.4 mm
- Infill: 10–20%
- Supports: As required by the slicer
- Brim: Recommended for tall or narrow sections
- Increase model scale for small details
Post Processing
- Remove supports carefully.
- Wash and cure resin prints according to the resin manufacturer's instructions.
- Sand visible support marks where required.
- Prime the model.
- Paint Obanai and the serpent-themed display base.
- Carefully assemble separate sword, snake, or effect components if applicable.
- Apply a protective clear coat if desired.
Always inspect the model in your slicer before printing and adjust orientation and supports according to your printer.
