Giyu Tomioka – Water Hashira 3D Printable Statue
Bring the Water Hashira to life with this detailed fan-made 3D printable statue of Giyu Tomioka from Demon Slayer: Kimetsu no Yaiba.
Giyu is sculpted in a dynamic combat pose with his Nichirin katana, signature half-and-half haori, detailed Demon Slayer uniform, flowing hair, and a dramatic water-themed display base.
The statue is designed as a premium collectible display piece with detailed sculpting across the face, hair, clothing, sword, and surrounding water effects.
Features
- Giyu Tomioka character statue
- Water Hashira design
- Dynamic katana combat pose
- Signature split-pattern haori
- Detailed Demon Slayer uniform
- Sculpted water effects
- Detailed display base
- Designed for resin 3D printing
- Suitable for collectors and anime fans
- Scalable to different display sizes
3D Printing
The model is suitable for resin printing and can also be adapted for FDM printing with appropriate scaling and support settings.
The model can be used as a display statue, collectible, cosplay decoration, or anime-themed 3D print.
This is a fan-made 3D model inspired by the Demon Slayer franchise.
Demon Slayer: Kimetsu no Yaiba and Giyu Tomioka are the intellectual property of their respective rights holders. This model is not an official or licensed product.
Recommended Printing SettingsResin / MSLA
Recommended for maximum detail.
- Layer Height: 0.03–0.05 mm
- Resin: Standard or high-detail resin
- Supports: Required where necessary
- Orientation: Angle the character to reduce large flat cross-sections
- Carefully support the sword, hands, hair tips, haori edges and water effects
- Check for islands and unsupported areas before printing
- Hollow large sections when appropriate
- Add suitable drainage holes when hollowing
- Wash and cure according to your resin manufacturer's instructions
FDM
The model can also be printed using FDM with suitable settings.
Suggested starting settings:
- Layer Height: 0.12–0.20 mm
- Nozzle: 0.4 mm
- Infill: 10–20%
- Supports: As required by the slicer
- Brim: Recommended for tall or narrow sections
- Increase model scale for small details
Post Processing
- Remove supports carefully.
- Wash and cure resin prints according to the resin manufacturer's instructions.
- Sand visible support marks where required.
- Prime the model.
- Paint Giyu and the display base.
- Assemble separate parts if applicable.
- Apply a protective clear coat if desired.
Always inspect the model in your slicer before printing and adjust orientation and supports according to your printer.
