Shinobu Kocho – Insect Hashira 3D Printable Statue
Bring the Insect Hashira to your collection with this detailed fan-made 3D printable statue of Shinobu Kocho from Demon Slayer: Kimetsu no Yaiba.
Shinobu is presented in an elegant yet dynamic combat pose with her distinctive Insect Breathing Nichirin sword, butterfly-inspired haori, detailed Demon Slayer uniform, and signature butterfly hair accessories.
The statue features a beautiful butterfly and wisteria-inspired display base with sculpted flowers, butterflies, and atmospheric effects, creating an elegant centerpiece for any anime or 3D-printing collection.
Features
- Shinobu Kocho character statue
- Insect Hashira design
- Insect Breathing theme
- Dynamic sword pose
- Distinctive Insect Breathing Nichirin sword
- Butterfly-inspired haori
- Butterfly hair accessories
- Detailed Demon Slayer uniform
- Wisteria and butterfly-themed display base
- Sculpted butterfly effects
- Detailed facial and hair sculpt
- Designed for resin 3D printing
- Suitable for collectors and anime fans
- Scalable to different display sizes
3D Printing
The model is designed primarily for resin 3D printing to preserve the fine details of the face, hair, clothing, sword, butterfly elements, and display base.
It can also be adapted for FDM printing with appropriate scaling, orientation, and support settings.
This is a fan-made 3D model inspired by the Demon Slayer franchise.
Demon Slayer: Kimetsu no Yaiba and Shinobu Kocho are the intellectual property of their respective rights holders. This model is not an official or licensed product.
Recommended Printing SettingsResin / MSLA
Recommended for maximum detail.
- Layer Height: 0.03–0.05 mm
- Resin: Standard or high-detail resin
- Supports: Required where necessary
- Orient the model to reduce large flat cross-sections
- Carefully support the sword, hands, hair tips, haori edges and butterfly elements
- Pay particular attention to thin sword and decorative sections
- Check for islands and unsupported areas before printing
- Hollow large sections when appropriate
- Add suitable drainage holes when hollowing
- Wash and cure according to your resin manufacturer's instructions
FDM
The model can also be printed using FDM with suitable settings.
Suggested starting settings:
- Layer Height: 0.12–0.20 mm
- Nozzle: 0.4 mm
- Infill: 10–20%
- Supports: As required by the slicer
- Brim: Recommended for tall or narrow sections
- Increase model scale for small details
Post Processing
- Remove supports carefully.
- Wash and cure resin prints according to the resin manufacturer's instructions.
- Sand visible support marks where required.
- Prime the model.
- Paint Shinobu and the butterfly/wisteria-themed display base.
- Carefully assemble separate sword, butterfly, or effect components if applicable.
- Apply a protective clear coat if desired.
Always inspect the model in your slicer before printing and adjust orientation and supports according to your printer.
