Modular 3D printable and repairable bike-mount for smartphone-holders. [Handlebars 22mm in diameter, different sizes may follow]

The gadget is designed to use as less material as possible while having the highest interoperabilty with already existing smartphone holders. Broken Clips might be reprinted and easily replaced within less than 10 minutes. [Note that you are operating with plastic. Please do not overtighten any screws!] The slides are Print-in-Place and need to be hit carefully with some weight to make them operational. Easy installation by using cable ties.

Settings

1. Layer Height: tested with 0.16 mm
2. Speed: tested with 100 mm/s
3. Infill: 100%
4. Supports: No
5. Filament: tested with PETG [ABS /ASA recommented for more durability]

Additionals

1. M3x8 Screw - 3x [2x length may differ for divergent smartphone holders]
2. M3 Nut - 3x
3. 160 - 2.5 mm Cable Tie - 2x
4. Eventually a strip of rubber as usually added for bicycle accessories [15 x Circumference of your Handlebars in mm]

Further applications in development ..

[No smartphone-holders included!]

Use at your own risk!

Human in progress, critiques are very welcome ..