Night Watch Ghost by CrystalDawn Prints.

A grumpy ghost lantern with an open underside and three face windows. Set it over a small battery powered LED tealight.

The model is approximately 4.95 inches wide (125.7 mm), 4.92 inches deep (124.9 mm), and 4.25 inches tall (108.0 mm).

This free download contains an STL model, a Creality K2 Plus 3MF print project, and a print guide. This is a free digital model, and no physical object is included.

The supplied Creality K2 Plus projects use a 0.4 mm nozzle, 0.16 mm layers, a 0.20 mm first layer, three walls, 10 percent gyroid infill, and an 8 mm outer brim. Supports are required. Supports are enabled for the model in the supplied 3MF. Keep them enabled when slicing. The saved PLA temperatures are 220 C for the nozzle and 50 C for the bed. Use temperatures appropriate for your filament and printer.

Print upright on the flat underside. Allow the bed to cool, remove the outer brim, and inspect the face and folded hem before use.

Use one battery powered LED tealight no larger than 40 mm in diameter and 25 mm in height. The ghost rests over the light. Check the actual fit before use. Use LEDs only, and never use a flame or hot bulb.