Hi

So it is a fully working computer case for ITX board.I'm in 100% author of this project, and i do not agree to edit it or publish it somewhere else without my aproval.I spend on it like 2 weeks of free time, and it was not that easy to design as someone might think.

What you need?

M5 and M4 screwsM5x14 - 5mm or 10mm, i do NOT recommend to go with longer. Because you can hit something on the motherboard. But for back panel you can go with any lenght.M4x16 - 5mm or 10mm longer could work too! (psst, you can even use m3 with just simple nut and washers ;d)For wind tunel use standard computer screws for fans

So about the features:

You can have up to 6 SSD with itSFX PSU aaand SFX-L (but cable management will be harder ;D)140mm front FAN, ON/OFF switch cutoutfully modular designprint without any supports!HEX design on front, MOBO trace, back panelcutouts for cable managementmaybe more in the futureFor print settings:

PETG for MOBO trace is a MUST and bare minimumnozzle 0.6mmInitial layer height 0.2mmlayer height 0.2mm220C on V4 chinesse hot-end for P1P :D, so for original one could be 240C?Ironing is nice for finish but sky rocked the print time (without 1D_22H and with 2D_11H :D :D :D)get your cooling right for your materialspeeeed, well it's kinda up to you. I'm going with transparent PET-G so 90mm/s and accel 6k. Also using a speed by height is a nice feature, cuz you can get your first 10mm really good and hard. So the print will be stronger without the need of using a lot of material!Infill gyroid 20% with 3000accel, don't go HIGHER with that, cuz your print peace will go flying trough the window with it :Duse brim for PSU bracket, rest should be fine without it.

If you have found that project good, here is a page where you can buy me a coffee and vote on what i will do next: https://ko-fi.com/thesunshinedude

Or just drop a like on my artstation: https://www.artstation.com/lukasz_kiebala

Support and request:kiebalalukasz2@gmail.comhttps://discord.gg/6NKQtxDTGQ

Best regards, Sunshine