Modular 3D printable and repairable bike-mount for smartphone-holders. Additional to the Basic Version the mount can be installed now to handlebars with different diameters.

The attempt was to design a device wich balances the use of material and the interoperabilty with already existing or selfmade smartphone holders in an optimal way. Broken Clips might be reprinted and easily replaced within less than 10 minutes. [Note that you are operating with plastic. Please do not overtighten any screws!] The slides are Print-in-Place and need to be hit carefully with some weight to make them operational. Easy installation by using cable ties.

Settings

1. Nozzle: tested with 0.4 mm
2. Layer Height: tested with 0.16 mm
3. Speed: tested with 100 mm/s
4. Infill: 100%
5. Supports: No
6. Filament: tested with PETG [ABS /ASA recommented for more durability]

Additionals

1. M3x8 Screw - 2x [length may differ for divergent smartphone holders]
2. M3x14 Screw - 1x
3. M3x20 Screw - 2x
4. M3 Nut - min. 5x
5. 160 - 2.5 mm Cable Tie - 2x
6. Eventually a strip of rubber as usually added for bicycle accessories [15 x Circumference of your Handlebars in mm]

Further applications in development ..

[No smartphone-holders included!]

Use at your own risk!

Human in progress, critiques are very welcome ..