A bright, high baffle custom made mouthpiece for alto saxophones. TIP OPENING: 1.90mmId recommend to print it in resin, table facing up and rotated 55 degrees. (table facing the resin tray)Supports are to be added based on experience, id recommend not crowding it with supports but if your slicer (like Lychee) has automatic support generation, use that instead.

Mouthpiece plays humbly and with a bright sound. If played slow, it will sound a bit dark and airy, so id recommend to push more air gently.

Post processing is needed!Sanding the cork bore with sandpaper to smooth it out. (If not, it will tear your cork up!) Sanding the reed contact points (table, facing curve, tip opening) with 1000 G, 2000 G and 5000 G is needed to form a good seal.

MAKE SURE THE MOUTHPIECE CURES COMPLETELY!

Any suggestions are welcome! and i can model at request!