The pen and paper become the mast and sails of this sailboat-inspired desk accessory, combining a functional pen holder with a custom name plate.

• Designed to hold pens between 9–12 mm in diameter
• Suitable for 75 × 75 mm (3 × 3 inch) and 80 × 80 mm block note (memo pad) sheets.
• Space at the back for an additional pen or other small office items such as USB flash drives, SD cards, paper clips, etc.

Model Details

The model consists of 3 parts:

• Base
• Hull
• Name Plate

The Base and Hull need to be glued together after printing. The Name Plate does not require glue and simply slides into the Base from either side.

Note About Name Plate:The Name Plate is provided as a blank file. You will need basic 3D software skills or another suitable method to create your custom name plate file.

Printing

The model is designed to be printed without supports. Two versions of the Hull are included:

• Standard Hull — designed to print without supports. Due to its relatively small contact area with the print bed, this version requires good bed adhesion. Using a brim is recommended
• Pre-supported Hull — includes a small additional support geometry for extra stability during printing