A beautiful 3D printable gift box with separate bow and ribbon for multiple colors. The box is kept closed by the ribbon parts that snap together. To open the box simply unsnap the ribbons (yes, you can "unwrap" this gift box!).

Box Bottom.stlThe bottom of the box. No special instructions to print this STL.

Box Top.stlThe top of the box. No special instructions to print this STL.

Ribbon Bottom.stlThe ribbon for the bottom of the box. No supports should be needed, but a high resolution print is recommended.

Ribbon Top.stlThe ribbon for the top of the box. Supports are needed, and a high resolution print is recommended.

Ribbon.stlEXTRA PART. This is not a required piece for the final print. It is an extra part that is un-split in case you want to do something else with it.

Bow.stlEXTRA PART. This is not a required piece for the final print. It is an extra part that is un-merged in case you want to do something else with it.

The bounding box for the assembled box is ~ 73.65 x 64.59 x 73.02 mm

The inner container area is ~ 5 cm cubed

Built in Blender, and the STL export .blend file is included. The Bow.stl and Ribbon Top.stl files were also run through Netfabb repair. So, if you re-export these STLs from Blender, you may want to run an analysis and repair from Netfabb afterwards.