Got ties to remove on your rail lines? This Extractor can pull more than its own weight.

This design has many elements from my tie shear design. However, several details have been changed. You can mix and match the Engine_Top and Gas_Tank_Shelf components between the two designs.

Hitch_Connector is the same as my Tie Shear and Speeder set designs. You can use this to connect components from all three designs.

Carefully file the Extractor_Holder and Rail_Clamp connection points so they snap into place on the frame. You will also need to file and sand parts and test fit them before glueing.

Extractor_Arm can be positioned close to the frame or extended and shown in photos.

There are several 0.5mm holes you can use fine wire in these to simulate hoses.

The frame has blocks were the parts fit between. Glue the Wheelset_rear part on first before Engine_Bottom.

Use last two 3D screenshots for reference on parts placement.

Please do not distribute the STLs or make prints for others. Design is for your personal use only.