Based on the character depicted in the animated series 'Kid Cosmic', Papa G (George) has been translated into 3D, capturing the most iconic and memorable characteristics presented in the show. Papa G stands just under 174mm without his hat and over 200mm with it, but can be scaled for printing. Be careful when scaling down, since the smaller and thinner aspects of the model will be more fragile or more difficult to print, depending on the printer and your chosen settings. Papa G haas been test printed on resin printers, but should print just fine on a well calibrated FDM. Papa G comes with 2 different options for the head, one with hat and one without. The head can be attached by sliding it onto the neck at the top of the body. When setting up supports and removing them, be sure to avoid or be wary of the small details, like the ring's gem and the feather. Try to avoid snipping or breaking them, if in direct contact with a support. Be patient and take your time when removing supports. Warm/hot water helps to reduce / avoid surface damage when removing supports from resin prints. If printed properly, simply snap the head into place. If cured separate from the body, the head can be swapped or posed to some degree. Papa G also comes with a base, with the symbol representing his multiplication stone, depicted in later episodes of the series. The parts are provided in STL and OBJ formats.