Orc Pirate Ship 3D print model

Sails and weapons are magnetizable but also have a peg as well. 3x2mm for the bottom sail and weapons, 2x2 for the top sails.Sails can be removed, and the front one can be replaced with an extra long chest and chain weapon.

The water is separate, but I have included options with it attached to the hull for ease of printing.The hull is solid so you can hollow it out.The weapons come in short, standard and long variations in case you'd like to mount them elsewhere on the ship.

And the cargo pieces can be used to hide the holes in the deck if you wish to move the weapons, or not use them.

Pre supported in lychee slicer and ready to print!

Due to sails spinning around in circular holes, I have made the sail holes square, and extended a square peg from the bottom of each sail so they sit inside the hull, instead of flush with the deck, reducing wobble and spin. (refer to last image)

I have also made sure these square holes can fit the wrecking ball as well, in case you decide to switch it up and put it in the middle of the ship!