ORC BUST - Height 150 mm 3D print model

This file is part of my Patreon welcome pack. To get this file at 100% off, support my Patreon. https://www.patreon.com/CloviSilva.

The 3D model is prepared and ready for 3D printing. Printing test performed on Creality LD-006 printer. Contents : Winrar file to unzip.In addition to the STL file, the chitubox file with supports is also included, the same one I used to do the test print. You can use it as a reference to place your brackets if you prefer.

Total de Pieces: 1Approximate Dimensions: 120x150mm

Tip for a good impression:

• Make sure your printer is calibrated
• Use the correct timing for your resin/printer
• After printing, wash the piece and remove the supports by hand or with the aid of pliers, remove carefully
• Cure your parts
• Finish your piece with sandpaper
• Paint your piece and make your collection. Thank you very much.

Hope you like it! ;D

Thank you for downloading and supporting! Please remember to rate my work ! thanks!