The 3D model is primed and ready for 3D printing. Print test performed on the Creality LD-006 printer.

Approximate Measurements Insect: 150x100x80mmApproximate Measurements Base: 200mm

Total de Pieces: 3

Tip for a good impression:

Make sure your printer is calibrated Use the correct timing for your resin/printer After printing, wash the piece and remove the supports by hand or with the aid of pliers, remove carefully Cure your parts Finish your piece with sandpaper Paint your piece and make your collection. Thank you very much. Hope you like it! ;D

Thank you for downloading and supporting! Please remember to rate my work ! thanks!