Based on the character depicted in the animated series of the same name, Kid has been translated into 3D, capturing the most iconic and memorable characteristics presented in the show. Kid stands just under 100mm, but can be scaled for printing. Be careful when scaling down, since the smaller and thinner aspects of the model will be more fragile or more difficult to print, depending on the printer and your chosen settings. Kid has been test printed on resin printers, but should print just fine on a well calibrated FDM. Kid comes with 3 different options for the head and body. Heads are heroic, 'confused' and 'angry' expressions, which were very common for Kid. More expressions may be added later. The body comes in neutral and cross armed poses. The head can be attached by sliding it onto the neck at the top of the bodies. When setting up supports and removing them, be sure to avoid or be wary of the small details, like the ring and antenna. Try to avoid snipping or breaking them, if in direct contact with a support. Be patient and take your time when removing supports. Warm/hot water helps to reduce / avoid surface damage when removing supports from resin prints. If printed properly, simply snap the head into place. If cured separate from the body, the head can be swapped or posed to some degree. Kid also comes with a base, with the symbol representing his telekenetic stone, depicted in later episodes of the series.