Based on the character depicted in the animated series 'Kid Cosmic', the Cosmech has been translated into 3D, capturing the most iconic and memorable characteristics presented in the show. The Cosmech stands just under 123mm, but can be scaled for printing. Be careful when scaling down, since the smaller and thinner aspects of the model will be more fragile or more difficult to print, depending on the printer and your chosen settings. Cosmech haas been test printed on resin printers, but should print just fine on a well calibrated FDM. The Cosmech comes with printable head and body. The head can be attached by sliding it onto the neck at the top of the body. When setting up supports and removing them, be sure to avoid or be wary of the small details. Try to avoid snipping or breaking them, if in direct contact with a support. Be patient and take your time when removing supports. Warm/hot water helps to reduce / avoid surface damage when removing supports from resin prints. If printed properly, simply snap the head into place. If cured separate from the body, the head can be swapped or posed to some degree. The parts are provided in STL and OBJ formats.