This print employs almost fully the build volume of your small printer and also looks pretty damn good!

Fits to most small 3d printers, like Ender 3 or Ultimaker 2. It does take a pretty long to print, but the satisfaction after it is ready, is all the more greater! Are you ready to accept the challenge?

Super simple to print, since no supports are needed. Use high quality PLA and it will look and feel good and carry your wine bottles with no problem! Protip: use matt spray paint to finish.

Printing info:

Footprint (to print): W: 200.4 mm L: 192.3 mm H: 200.0 mm

Material recommendation (tested): high quality PLAPost processing software recommended: Ultimaker Cura 4.5 or later

Setting recommendations:

In general, do not attempt this as your first ever print.It will take a relatively long time to print. Use settings you have already tested with something similar and which work with you printer.

Built plate adhesion: min. 8 mm brim.If you have problems with prints not sticking properly, fix those problems before attempting. Check bed cleanliness / bed temp / bed leveling / etc.

Layer height: 0.28 mm (the less, the better looking result, but also more build time!)Wall thickness: min. 2 layers / 0.8 mm

Pay attention that post does not place any wall seams to visible places!

Infill pattern: CubicInfill density: min. 12%